Electronics Forum | Sat Jul 25 08:47:25 EDT 2009 | davef
Both "moisture content of bare board" and the "thickness of the copper plating in the PTH" are related to each other. As you heat the solder connection, moisture in the board boils and out-gasses through the solder connection. Plating with the proper
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
Electronics Forum | Mon May 12 15:13:29 EDT 2014 | emeto
Thank you guys. As we are speaking I keep examine the problem and here is what I got so far. 1. I measured the temperatures on my profile and the lead is hotter than the board. The lead goes 12 seconds earlier than the pad and is taking the solder.
Electronics Forum | Wed Aug 23 19:01:54 EDT 2000 | kbmacg
For high temperature electronics, operating in 225�C ambient environments, most solders can not be used. The high-lead solders all have difficulties of one sort or another. Is their anything new regarding useful high melting point solders? Especially
Electronics Forum | Fri Sep 08 04:45:17 EDT 2000 | PeterB
As per Travis's reply it could be something other than the reflow process. Another good one is if the printed PCB's have been cleaned down due to print misregistration etc.. If not properly controlled paste residues can remain distributed about the p
Electronics Forum | Tue Jan 14 19:41:32 EST 2020 | avillaro2020
Hi Evtimov, Thanks for your response. Yes, the vapour phase is suppose to handle big and heavy boards, at least thats the intention. Well our thin board is like around 3mm which is not really thin. In our application the thicker the boards means more
Electronics Forum | Sun Jul 26 17:13:31 EDT 2009 | slthomas
Is it possible that the assembler is using solder wire that's too small for the application and feeding it too quickly to compensate?
Electronics Forum | Wed Aug 21 13:28:20 EDT 2019 | ameenullakhan
And what is the solder paste selection recommendation for the same. 1. Water soluble ( organic based flux solder based ) 2. No clean ( rosin or resin based solder paste ) customer is suggesting water soluble chemistry , which is having lot hot an
Electronics Forum | Mon Nov 26 09:33:49 EST 2018 | charliedci
The problem you create by soldering from solder destination side (presuming you have already soldered from other side) is that you will trap air in PTH so you have virtually no continuous solder in PTH from one side to other. This will not meet IPC-A
Electronics Forum | Wed Jul 30 00:47:10 EDT 2014 | matusov
Hello gurus, I am a hardware designer with a small company. We are about to send a new PCB for fabrication. This board uses dozens of tiny QFN, DFN, and similar packages. As a final check I have been going through the datasheets of all these parts t